
Technical Specification :
D C WELDING | Model | HPW 7000 D | |
Maximum Output (Duty Cycle 60%) | 200 Amps. | ||
Working Voltage | 20v to 32v | ||
Open Circuit Voltage | 65 Volt (Maximum) | ||
Current Regulation Amps | 40-200 Amps. | ||
Rectifying Mode | SCR, Phase Controlled 3-phase, Rectifying Bridge | ||
Maximum Electrode diameter | 2.6 mm to 4 mm | ||
AC GENERATOR | Type | Brush less with Rear Earth Magnet Rotor. | |
AC. Voltage On Eco Mode | N/A | ||
AC. Voltage On Power Mode (No Load) | 250 Volts (No Load) + 10 Volts, Single Phase | ||
Rated Current | 12 Amps. | ||
NFB | 12 Amps. | ||
Rated Power | 2500 VA | ||
Peak Power | 3000 VA | ||
Frequency | 50 to 60 Hz | ||
Class of Insulation | F | ||
ENGINE | Model | TP186F | |
Type | 4-Stroke, OHV, Single Cylinder, direct Injection, Swirl Chamber, Inclined type | ||
Maximum Power | 10HP | ||
Bore x Stroke | 86X72 mm | ||
Displacement | 416 cc | ||
Starting System | Recoil / Self Start | ||
Ignition System | | ||
Fuel | Standard Diesel | ||
Fuel Tank Capacity | 13 Liters | ||
Fuel Consumption # Ltr./Hr. | 1.1 Ltr./hr. | ||
Continuous Operating Hour | 12 hr. | ||
Lube. Oil Capacity | 1650 ml. | ||
Lubricating Oil Consumption | 4.3 gm./Hr. | ||
Standard Accessories | AC Plug | 1 Pcs. | |
Tool Kit | 1 Set | ||
Welder Holder | 1 Set | ||
Earthing Clamp with Cable | 1 Set | ||
Oil Funnel | 1 No. | ||
Owner’s Manual | 1 No. | ||
Battery Terminal | 1 Set | ||
Battery Tray & Holding Set | 1 Set | ||
Optional Accessories | Sheet Metal Welding Attachment (Helps to adjust low current upto 50 Amps.) | 1 Kit (Additional Cost) | |
Costar Wheels | Optional (Wheels & Handle Sets) @ (Additional Cost) | ||
Panel & Other Standard Features | A.C. Circuit Protector | Yes | |
Engine Oil Protection | yes | ||
Low Fuel Protection | yes | ||
A.C. Pilot Lamp | Yes | ||
Fuel Level Gauge | yes | ||
A.C. Output Sockets | 1 No. | ||
Packing | Dimension LxWxH (mm) | 710x500x600 mm | |
Dry Weight (Kgs.) | 110 Kgs. | ||
Above Specifications are for reference only, Because of continuous improvements and up-gradation by our R&D team. This specification’s can change without any prior intimation |